Specs
Plinth: 3 Ply Bamboo laminate 19.05mm (3/4″)
Motor: Single 24 Pole Synchronous
AC Motor Pulley: Brass Pulley
Speed: 33.3 & 45 rpm
Drive: Belt Drive
Platter: 3-ply Bamboo Laminate 19.05mm (3/4″)
Spindle: Removable Spindle Cover
Sub Platter: Aluminum Sub Platter with Steel Shaft
Legs: Leveling Legs
Bearing: Bronze Collar Bearing with ABEC7
Carbonized Ceramic Ball Bearing
Dimensions: H 15.5cm x W 40.9cm x L 33.3cm
     8 1/4″ x 16″ x 32.39

Phono Details
Phono Amp: 5mv, 47ohm Cartridges
MM/MC: MM only
Bypass Switch: Phono Bypass Switch for use with an
external phono amp.
Arm Details
The S Series 9” (222mm) arm comes pre mounted
on either version of the S series turntable.
The tone arm features the same handmade bambo
design, soaked in hemp like our table design.
Material: Three Ply Bamboo Laminate 12mm
Settings: VTA & Azimuth Adjustments
Anti-Skate Adjust: Passive Anti-Skate
Bearing Assembly: Bronze with Brass Collar Spike
and Synthetic, High Viscosity Grease
Bearing Arm Base: Bamboo Supports on Plinth
Wiring: Cardas Wire 33 AWG Uninterrupted
from Head shell Clips to Brass Female RCA with
Silver Plated Cartridge Clips
Level: Micro Bubble Level Included
‍

‍
Arm Length: 9″ / 222 mm
Tone Arm Mass: 10gCartridge Details
*Only available on PID# 20489
Type: Moving Magnet
Stylus: Elliptical Bonded
Cantilever: Aluminum Pipe
Load Impedance (Recommended): 47K Ohms
Load Capacitance (Recommended): 100 – 200 pF
Frequency Response: 20 – 22,000 Hz
Output V: 4.0mV
Channel Separation: 20db (1KHz)
Body: Bamboo
Coating: Napheline
Weight: 5.2 Grams
Replacement Stylus: Re-tipping Available
Cartridge Mounting Kit: Yes
Tracking Force: 1.8g to 2.2g (2.0 Tested)

‍

‍

‍